Marijuana Test

Instructions: The marijuana test urine sample should be collected in a clean glass or plastic container. Open the foil pouch at the notch and remove the marijuana test kit. Pull the protective cap off the bottom of the test to reveal the absorbent testing strips. Do not discard the protective cap. Carefully dip the testing strips into the urine sample. Do not allow the urine to touch the plastic casing of the test. Allow the test to absorb some urine- You will be able to see the urine moving up through the windows. After 5 to 10 seconds, remove the marijuana test from the urine. Replace the protective cap over the testing strips and lay the test on a clean, flat surface while the marijuana test lines develop. Do not interpret results after 10 minutes.

These marijuana test panels are for customers who would like to test themselves in the privacy of their own home, office, etc. This is a SIX panel test kit that detects for MARIJUANA TEST, COCAINE, METH/AMP, OPI, BENZO & OXY. It will test at the same levels as an actual laboratory test.

Our test panels conform with NIDA/SAMHSA guidelines to provide a "positive" or "negative" result according to established cutoff levels. This is the most commonly used marijuana test for drug use (aka dip stick). Their technical term is Enzyme Multiple Immunoassay Test (EMIT). This is commonly referred to in the industry as the 5/50 test or DB 550 and is made by Dade Behring. Toxins are tested for with the cutoff being 50 ng/ml.

NOTE: The Instant Clean Additive should not be used with these marijuana test panels for several reasons:

• It takes about 90 minutes to fully on destroy all toxins
• It breaks the toxins up into several pieces.

For reasons such as these, the Instant Clean Additive will often lead to a false positive with these marijuana test panels. If you need an additive that works for an 'on the spot' dip stick type test, look at our Spike Additive for that type of marijuana test.

Our test panels have a 100% detection and success rate!